SERVICE HP

hp service?
practically easy also practically difficult also.
Why easy?
sometimes by doing a cleansing and drying only hp can be normal again. maybe this is all because of the crust crust that sticks to the hp components prevent a voltage so causes the component to work less than the maximum. then after the washwith a thinner crust and the crust is missing components workwith the maximum.
really difficult?
Just imagine how many layers of hp board is definitely more thanthree. by simply using a path of golden thread components areinterconnected, the path must also be broken.
if he decided on the outer layer still good but if we break up in thesure will have trouble.
not to mention the problem in its software that can make dizzy.
perhaps with visiting pal pal pal on this blog can problem solve.
yes essentially the same as we learn, if my friend would alsopresumably have experience to share with us.

Read more ►

1200 SIM CARD WAYS

This time we made a path sim card scheme and how to jumper simdrivers
because ic driver close to the sim connector and the connector isusually highly flammable because it is made of plastic so we lifted icsafer with solder
then we foot jumper the appropriate image above

Read more ►

N70 LCD WAYS

for my friend who face cases n70 lcd white blink this scheme may be able to help. I never faced such a case, again and again I check thetp line not broken so there is a driver IC also my locker a few timesalready but still the same.
by looking at pictures from a book I think ni IC can be jumper and then I started to jumper one / one and ultimately successfulalhamdulillah
so dizzy from it than my friend here see the picture in the book I tried to picture a simple
good luck good luck ...........

Read more ►

3110c KEYPAD WAYS

Check the keypad if one of the 3110c keypad not working, with the above scheme may help buddy buddy all
Our image is a red circle keypad driver friend also could try todestabilize the IC
good luck .....

Read more ►

7610 LCD WAYS

Pictured above is the image path to the connector line lcd 7610 for this step my friend can shake a driver in a red circle markedwith a view over the buddy scheme can also check the pathif you are unsure of the function buddy drivers can also be jumper

Read more ►

3100 SWITCH ON/OFF PROBLEM

Sometimes we often find the path on / off 3100/6100 lifted and we are so confused how to install the switch,
do not need to attach the first puzzled the switch we can use glueiron firmly attached so the switch will not worry about loose again.
after the glue dried we just connect the foot switch with a jumperwire.
to make it easier you can see the picture above
SUCCESS FOR YOU

Read more ►

TRICKS JUMPER DRIVER LCD 6600

Sometimes we find a case of 6600 when the lcd lcd white blink that we put a normal, good lcd connector, even over and over againwe've replaced the driver IC which is located below the LCDconnector, but the screen stays white blink.
answer whether you believe after replacing the IC condition is stillworking fine, if not sure then we should replace the IC with a jumperwire.
how to jumpers you can see the picture above as a note before you start make sure the legs are in step over all the jumper wire GND
GOOD LUCK TRYING

Read more ►

schematic charger N73

The following schematic N73 charger

picture above shows the schematic for the circuit of the interface to the driver IC charger. if you are experiencing a case of n73 notcharging the components that need to be in check is the picture thatwe circled in red.
good luck

Read more ►